Get to Know What You Must Do When You Hang Wall Cabinets
You know very well that the kitchen cabinets are available in so many retail locations and you must not be afraid to install them on your own. This is a fantastic DIY project. Through these tips, you will be able to save time as well as prevent those costly mistakes from happening during your installation. If you are able to succeed during the first wall cabinet installation process, then there is no doubt that you can do so again in the future.
You have to secure these important wall cabinet tools like the miter saw, stud finder, jigsaw, pry bar, drill bit set, level, clamps, hole saw kit, 2 foot level, 2 cordless drills, 4-in-1 screwdriver and the 4 foot level. What you must do first is to mark the wall so that you can know the layout. With this, you will be able to avoid yourself from getting surprised during the installation of the wall cabinet. Find the highest point in the floor and draw a 34 1/2″ line up while marking this as the top of your cabinet’s base. You can then measure up 19 1/2 inches from that line and then draw another line which will be the bottom of the wall cabinet. You need to measure and mark the layout for every wall cabinet on your wall. As you install the first cabinet, you have to draw a vertical line. You can then mark the stud locations on the wall below where the cabinet’s bottom will hang.
On the installation process, you must remove the cabinet shelves and doors first. In doing so, you can make the cabinet lighter. You also won’t have difficulty as you hang it.
You should be checking the wall through holding the 4 foot level against this so that you can assess if there are major dips or bumps which you should be concerned about. You will not have much difficulty in hanging the cabinet when you don’t lean over the base cabinets. You must then screw the ledger board on the mark for the cabinet’s bottom. You have to screw this into two studs, 2 or 3 is okay. You can rest the cabinet on the ledger board for you to achieve a straight alignment and to hold the cabinet in place when you screw this to the wall.
Work on screwing all the other things that you should be screwing in place. For the outer edges of the cabinet, it is best that you use four screws. If the cabinet is smaller, then you can just have a couple of screws inside.
What you can then do next is to reinstall the doors and ensure if they work properly. You must be extra cautious when you will be redriving the screws in the hinges. Screws are usually made from metal that is fairly soft, making the heads easy to strip and also the shafts easy to snap off.